Power Door Locks/Rke; Decklid Release Output Open - Dodge ZB 2005 Service Manual

Symptom:

DECKLID RELEASE OUTPUT OPEN

When Monitored and Set Condition:
DECKLID RELEASE OUTPUT OPEN
When Monitored: Whenever the Decklid Release is activated.
Set Condition: The Body Control Module supplies the current to the Decklid Release
Solenoid when the command to release is received. If the Release Driver current draw is
less than 0.1 amp when the output is turned on, this code will set.
DTC PRESENT
GROUND CIRCUIT
DECKLID RELEASE SOLENOID
DECKLID RELEASE DRIVER WIRE OPEN
BODY CONTROL MODULE - DECKLID RELEASE DRIVER OPEN
TEST
1 Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Decklid Release several times.
With the DRBIII , read DTCs.
Does the DRBIII display DECKLID RELEASE OUTPUT OPEN?
Yes → Go To 2
→ The condition that caused the code to set is not present at this
No
2 Disconnect the Decklid Release Solenoid.
Using a 12-volt test light connected to 12-volts, check the Ground circuit at the
solenoid connector.
Does the test light illuminate brightly?
Yes → Go To 3
→ Repair the Ground circuit for an open.
No
POSSIBLE CAUSES
ACTION
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.

POWER DOOR LOCKS/RKE

291
APPLICABILITY
All
All