Driver Seat Belt Tensioner Short To Battery - Dodge ZB 2005 Service Manual

AIRBAG
Symptom:

DRIVER SEAT BELT TENSIONER SHORT TO BATTERY

When Monitored and Set Condition:
DRIVER SEAT BELT TENSIONER SHORT TO BATTERY
When Monitored: With the ignition on the ACM monitors the voltage of the Driver Seat
Belt Tensioner circuits.
Set Condition: The ACM has detected high voltage on the Driver Seat Belt Tensioner
circuits.
DRIVER SEAT BELT TENSIONER SHORT TO BATTERY
DRIVER SBT LINE 1 OR LINE 2 SHORT TO BATTERY
ACM, DRIVER SEAT BELT TENSIONER CIRCUITS SHORT TO BATTERY
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1 NOTE: Ensure the battery is fully charged.
Turn the ignition on.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
2 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE
PROCEEDING.
Disconnect the Driver Seat Belt Tensioner connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Driver SBT connector.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active DTC's.
Does the DRBIII display DRIVER SEAT BELT TENSIONER SHORT TO BAT-
TERY?
Yes → Go To 3
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 5
→ Replace Driver Seat Belt Tensioner in accordance with the Service
Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
44
APPLICABILITY
All
All