Dodge ZB 2005 Service Manual page 1480

Symptom:
PASSENGER SEAT BELT SWITCH SHORT TO BATTERY
When Monitored and Set Condition:
PASSENGER SEAT BELT SWITCH SHORT TO BATTERY
When Monitored: The ACM monitors the Seat Belt Buckle Switch circuit for an short to
battery.
Set Condition: The code will set if the ACM detects high circuit voltage.
PASSENGER SEAT BELT SWITCH CIRCUITS SHORTED TO BATTERY
PASSENGER SEAT BELT SWITCH SHORT TO BATTERY
ACM, PASSENGER SEAT BELT SWITCH SHORT TO BATTERY
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1 Ensure the battery is fully charged.
Turn the ignition on.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 Turn the ignition off.
NOTE: Ensure that the battery is fully charged.
Disconnect the Passenger Seat Belt Switch connector.
NOTE: Check connectors - Clean and repair as necessary.
Turn the ignition on.
With the DRBIII , read the active Airbag DTCs.
Does the DRB show PASSENGER SBS CIRCUIT OPEN?
Yes → Replace the Passenger Seat Belt Switch Buckle Assembly.
→ Go To 3
No
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
POSSIBLE CAUSES
ACTION
Go To 2
Go To 4
Perform AIRBAG VERIFICATION TEST - VER 1.
99
AIRBAG
APPLICABILITY
All
All