Dodge ZB 2005 Service Manual page 1512

Table of Contents

Advertisement

Symptom:
PASSENGER SQUIB 2 SHORT TO GROUND
When Monitored and Set Condition:
PASSENGER SQUIB 2 SHORT TO GROUND
When Monitored: When the ignition is on, the ACM monitors the resistance of the
Passenger Squib 2 circuits for low resistance.
Set Condition: The ACM has detected a short to ground in the Passenger Squib 2 circuits.
PASSENGER AIRBAG CIRCUIT SHORTED TO GROUND
PASSENGER SQUIB 2 LINE 1 OR LINE 2 SHORT TO GROUND
ACM, PASSENGER SQUIB 2 CIRCUIT SHORT TO GROUND
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1
NOTE: Ensure that the battery is fully charged.
Turn the ignition on.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Passenger Airbag connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Passenger Airbag connector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag DTCs.
Does the DRB show PASSENGER SQUIB 2 CIRCUIT SHORT TO GROUND?
Yes → Go To 3
→ Replace the Passenger Airbag in accordance with the Service
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 4
Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
131
AIRBAG
APPLICABILITY
All
All

Advertisement

Table of Contents
loading

Table of Contents