Chime; Chime Inoperative - Dodge ZB 2005 Service Manual

Symptom:

*CHIME INOPERATIVE

USE DRB TO ACTUATE CHIME
CHIME DRIVER CIRCUIT - OPEN
CHIME DRIVER CIRCUIT - SHORT TO GROUND
CHIME DRIVER CIRCUIT - SHORT TO VOLTAGE
INSTRUMENT CLUSTER
BCM
TEST
1 With the DRBIII , actuate the CHIME. (BCM actuator)
Does chime sound a warning?
Yes → The chime operates as it should. Check other reasons for the
→ Go To 2
No
2 Turn the ignition off.
Disconnect the Instrument Cluster harness connector(s).
Disconnect the BCM C4 harness connector.
Using a 12-volt test light connected to 12-volts, check the chime driver circuit for a
short to ground.
Does the test light illuminate brightly?
Yes → Repair the chime driver circuit for a short to ground.
→ Go To 3
No
3 Turn the ignition off.
Disconnect the Instrument Cluster harness connector(s).
Disconnect the BCM C4 harness connector.
Turn the ignition on.
Using a DVOM connected to ground, check the chime driver circuit for a short to
voltage.
Is the voltage above 5.0 volts?
Yes → Repair the chime driver circuit for a short to voltage.
→ Go To 4
No
POSSIBLE CAUSES
ACTION
chime being inoperative and select from the symptom list.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
143

CHIME

APPLICABILITY
All
All
All