Dodge ZB 2005 Service Manual page 1462

Symptom:
NO PCI TRANSMISSION
When Monitored and Set Condition:
NO PCI TRANSMISSION
When Monitored: With the ignition on and the module transmitting information on the
PCI BUS.
Set Condition: The code will set if the onboard diagnostic cannot detect the module
transmitting information on the PCI BUS for 4 consecutive seconds. NOTE: Any PCI Bus
Failure will may cause a stored code to set.
AIRBAG CONTROL MODULE - ACM
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1 NOTE: Ensure that the battery is fully charged.
IF THE MODULE IS DROPPED AT ANY TIME, IT MUST BE REPLACED.
Turn the ignition on.
From the list below, select the appropriate module and DTC type for the this
diagnostic trouble code.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
Select the appropriate module and type of DTC
ACM - ACTIVE
ACM - STORED
POSSIBLE CAUSES
ACTION
Replace the Airbag Control Module in accordance with Service
Instructions.
Perform AIRBAG VERIFICATION TEST - VER 1.
Go To 2
81
AIRBAG
APPLICABILITY
All