Symptom:
INTERNAL BCM FAILURE
When Monitored and Set Condition:
INTERNAL BCM FAILURE
When Monitored: Continuously.
Set Condition: The DTC will set if the BCM detects an internal fault.
INTERNAL BCM FAILURE
TEST
1
Connect the DRB to the Data Link Connector.
Turn the ignition on.
With the DRB, erase BCM DTC's.
Turn the ignition off then turn the ignition on.
With the DRB, read BCM DTC's.
Did this DTC reset?
Yes → Replace the Body Control Module in accordance with the service
→ Test Complete.
No
POSSIBLE CAUSES
ACTION
information.
Perform BODY VERIFICATION TEST - VER 1.
149
COMMUNICATION
APPLICABILITY
All