Dodge ZB 2005 Service Manual page 1703

POWER DOOR LOCKS/RKE
RKE PROGRAM LINE OUTPUT OPEN/SHORT TO GROUND —
TEST
3 Turn the ignition off.
Disconnect the Remote Keyless Entry Module connector.
Disconnect the Body Control Module C4 connector.
Measure the resistance of the RKE Module Program Enable circuit between the RKE
Module connector and the BCM C4 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 4
→ Repair the RKE Module Program Enable wire for an open
No
4 Turn the ignition off.
Disconnect the Remote Keyless Entry Module connector.
Disconnect the Body Control Module C4 connector.
Measure the resistance of the RKE Module Program Enable circuit to ground.
Is the resistance below 1000.0 ohms?
Yes → Repair the RKE Module Program Enable wire for a short to
→ Go To 5
No
5 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Remote Keyless Entry Module.
Perform BODY VERIFICATION TEST - VER 1.
322
Continued
APPLICABILITY
All
All
All