Dodge ZB 2005 Service Manual page 1675

POWER DOOR LOCKS/RKE
DECKLID RELEASE OUTPUT SHORT TO GROUND —
TEST
3 Turn the ignition off.
Disconnect the Decklid Release Solenoid connector.
Disconnect the BCM C2 harness connector.
Measure the resistance between ground and the Decklid Release Driver circuit.
Is the resistance below 1000.0 ohms?
Yes → Repair the Decklid Release Driver circuit for a short to ground.
→ Replace the Body Control Module.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
294
Continued
APPLICABILITY
All