Passenger Exterior Door Handle Switch Stuck - Dodge ZB 2005 Service Manual

Symptom:

PASSENGER EXTERIOR DOOR HANDLE SWITCH STUCK

When Monitored and Set Condition:
PASSENGER EXTERIOR DOOR HANDLE SWITCH STUCK
When Monitored: At all times when battery power is supplied to the Body Control
Module.
Set Condition: When the BCM senses a passenger exterior door handle switch input on
the passenger Door Switch Mux circuit for over 10 seconds, this code will set.
DTC PRESENT
PASSENGER DOOR SWITCH MUX CIRCUIT SHORT TO GROUND
PASSENGER EXTERIOR DOOR HANDLE SWITCH SHORTED
PASSENGER DOOR SWITCH MUX CIRCUIT SHORT TO DRIVER DOOR SWITCH RETURN
BODY CONTROL MODULE - PASSENGER DOOR SWITCH MUX CIRCUIT SHORTED
TEST
1 NOTE: When this code is present, the VTSS indicator will stay on solid during the
arming process.
With the DRBIII , record and erase DTC's.
Cycle the ignition switch from ON to OFF to ON.
With the DRBIII , read DTC's.
Lower the passenger door window.
Remove the key and operate the Passenger Exterior Door Handle Switch several
times while monitoring the DRBIII .
Wait 10 seconds.
Does the DRBIII
STUCK?
Yes → Go To 2
→ Check the switch for a binding condition and replace if necessary.
No
2 Disconnect the Passenger Exterior Door Handle Switch connector.
With the DRBIII in Sensors, read the PASS DOOR ENTRY voltage.
Is the voltage above 4.75 volts?
Yes → Replace the Passenger Exterior Door Handle Switch.
→ Go To 3
No
POSSIBLE CAUSES
ACTION
display PASSENGER EXTERIOR DOOR HANDLE SWITCH
Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
315
APPLICABILITY
All
All