Headlamp Washer Relay Short To Battery (Export Only) - Dodge ZB 2005 Service Manual

Symptom:
HEADLAMP WASHER RELAY SHORT TO BATTERY (EXPORT
ONLY)
When Monitored and Set Condition:

HEADLAMP WASHER RELAY SHORT TO BATTERY (EXPORT ONLY)

When Monitored: With the Ignition On.
Set Condition: This DTC will set if the BCM senses an over current condition on the
Headlamp Washer Pump Relay Control circuit.
DTC PRESENT
FAULTY HEADLAMP WASHER PUMP RELAY
HEADLAMP WASHER PUMP RELAY CONTROL CIRCUIT SHORT TO VOLTAGE
BODY CONTROL MODULE
TEST
1 With the DRBIII , record and erase DTC's.
With the DRBIII , read DTC's.
Attempt to operate the Headlamp Washers while monitoring the DRBIII .
Does the DRBIII display HEADLAMP WASHER RELAY SHORT TO BATTERY?
Yes → Go To 2
→ The condition that caused this DTC to set is currently not present.
No
2 Turn the ignition OFF.
Disconnect the Body Control Module C4 connector.
Disconnect the Headlamp Washer Pump Relay.
Turn the ignition ON.
Measure the voltage between ground and the Headlamp Washer Relay Control
circuit.
Is the voltage above 5.0 volts?
Yes → Repair the Headlamp Washer Pump Relay Control circuit for a
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Using the wiring diagram/schematic as a guide, inspect the
related wiring harness and connectors for a possible intermittent
condition.
Perform BODY VERIFICATION TEST - VER 1.
short to voltage.
Perform BODY VERIFICATION TEST - VER 1.
WINDSHIELD WIPER & WASHER
401
APPLICABILITY
All
All