Dodge ZB 2005 Service Manual page 1631

IGNITION, POWER, ACCESSORY
BCM - IGNITION RUN 2 SHORT —
TEST
2 NOTE: All components identified in Test Number 1 must be disconnected
from the BCM's Fused Ignition Switch Output (Run) circuit and the DTC
must still be present for the result of the test to be valid.
Turn the ignition off.
Disconnect the BCM C2 harness connector.
Measure the resistance between ground and the Fused Ignition Switch Output (Run)
circuits in the BCM C2 harness connector.
Using the wiring diagram/schematic as a guide, disconnect the appropriate compo-
nent harness connector.
Is the resistance below 10k ohms on any of the circuits?
Yes → Repair the Fused Ignition Switch Output (Run) circuit for a short
→ Replace and program the Body Control Module in accordance
No
ACTION
to ground.
Perform BODY VERIFICATION TEST - VER 1.
with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
Continued
250
APPLICABILITY
All