Dodge ZB 2005 Service Manual page 1722

DRIVER WINDOW HALL EFFECT FAILURE —
TEST
7 Turn the ignition off.
Disconnect the Window Motor connector.
Disconnect the BCM C3 harness connector.
Measure the resistance between ground and the Driver Window Hall Signal circuit.
Is the resistance below 1000.0 ohms?
Yes → Go To 8
→ Repair the Driver Window Hall Signal circuit for a short to
No
8 If there are no possible causes remaining, view repair.
Repair
9 Turn the ignition off.
Disconnect the Window Motor connector.
Turn the ignition on.
Connect a 12-volt test light between the Driver Window Up Driver and the Driver
Window Down Driver circuits in the motor connector.
Press the Driver Window Switch UP and DOWN.
Does the test light illuminate brightly when the switch is in either position?
Yes → Replace the Driver Power Window Motor.
→ Go To 10
No
10 Turn the ignition off.
Disconnect the Window Motor connector.
Disconnect the BCM C2 connector.
Measure the resistance of the Driver Window Down Driver circuit between the BCM
C2 connector and the Motor connector.
Is the resistance below 5.0 ohms?
Yes → Go To 11
→ Repair the Driver Window Down Driver circuit for an open.
No
11 Turn the ignition off.
Disconnect the Window Motor connector.
Disconnect the BCM C2 connector.
Measure the resistance of the Driver Window Up Driver circuit between the BCM C2
connector and the Motor connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
→ Repair the Driver Window Up Driver circuit for an open.
No
ACTION
ground.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
341
POWER WINDOWS
APPLICABILITY
All
All
All
All
All