Dodge ZB 2005 Service Manual page 1485

Table of Contents

Advertisement

AIRBAG
PASSENGER SEAT BELT TENSIONER CIRCUIT OPEN —
TEST
2
NOTE: Ensure the battery is fully charged.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE
PROCEEDING.
Disconnect the Passenger SBT connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool and jumper to the Passenger SBT connector.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active DTC's.
Does the DRBIII display PASSENGER SBT CIRCUIT OPEN?
Yes → Go To 3
→ Replace the Passenger Seat Belt Tensioner in accordance with the
No
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
3
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE
PROCEEDING.
Disconnect the Airbag control Module connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool adaptor to the ACM connector.
Disconnect the Load Tool jumper from the Passenger SBT connector.
Measure the resistance of the Passenger Seat Belt Tensioner Line 1 and Line 2
circuits between the Load Tool adaptor and the Passenger SBT connector.
Is the resistance below 1.0 ohms on either circuit ?
Yes → Go To 4
→ Repair open or high resistance in Passenger Seat Belt Tensioner
No
4
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE
PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
If there are no possible causes remaining, view repair.
Repair
ACTION
Service Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
Line 1 or Line 2 circuits.
Perform AIRBAG VERIFICATION TEST - VER 1.
Replace the Airbag Control Module in accordance with the Service
information.
Perform AIRBAG VERIFICATION TEST - VER 1.
104
Continued
APPLICABILITY
All
All
All

Advertisement

Table of Contents
loading

Table of Contents