Dodge ZB 2005 Service Manual page 1584

RIGHT HIGH BEAM OUTPUT SHORT —
TEST
3 Turn the ignition off.
Disconnect the Right High Beam Headlamp connector.
Turn the ignition on.
Turn the High Beams on.
Using a 12-volt test light connected to ground, check the Right High Beam Output
circuit.
Does the test light illuminate brightly?
Yes → Replace the High Beam Headlamp.
→ Replace the Body Control Module.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
EXTERIOR LIGHTING
Continued
203
APPLICABILITY
All