Abs Messages Not Received - Dodge ZB 2005 Service Manual

INSTRUMENT CLUSTER
Symptom:

ABS MESSAGES NOT RECEIVED

When Monitored and Set Condition:
ABS MESSAGES NOT RECEIVED
When Monitored: With the ignition On.
Set Condition: The Instrument Cluster detects no ABS messages received for 5 ± 1
seconds.
INTERMITTENT CONDITION
NO RESPONSE - PCI BUS - ABS
INSTRUMENT CLUSTER
TEST
1 Turn the ignition on.
With the DRBIII , attempt to I/D or communicate with the ABS Module.
Is there a response from the ABS Module?
Yes → Go To 2
No
2 With the DRBIII , erase the DTC from the Instrument Cluster.
Cycle the ignition and wait approximately 1 minute.
With the DRBIII , read DTCs.
Did this DTC reset?
Yes → Replace the Instrument Cluster in accordance with the Service
No
POSSIBLE CAUSES
ACTION
→ Refer to symptom *NO RESPONSE FROM CAB CONTROLLER
in the Communication category.
Perform BODY VERIFICATION TEST - VER 1.
Information.
Perform BODY VERIFICATION TEST - VER 1.
→ The condition is not present at this time. Monitor DRBIII
parameters while wiggling the related wire harness. Refer to any
Technical Service Bulletins (TSB) that may apply. Visually in-
spect the related wiring harness and connector terminals.
Perform BODY VERIFICATION TEST - VER 1.
272
APPLICABILITY
All
All