Replacing The Srx5400 Services Gateway Scb; Removing The Srx5400 Services Gateway Scb; Installing An Srx5400 Services Gateway Scb; Replacing The Srx5400 Services Gateway Routing Engine - Juniper SRX5400 Hardware Manual

Related
Documentation
Operating and Positioning the SRX5400 Services Gateway SCB Ejectors
Related
Documentation

Replacing the SRX5400 Services Gateway SCB

Copyright © 2014, Juniper Networks, Inc.
Operating and Positioning the SRX5400 Services Gateway SCB Ejectors on page 113
Removing the SRX5400 Services Gateway SCB on page 114
Installing an SRX5400 Services Gateway SCB on page 114
Replacing the SRX5400 Services Gateway Routing Engine on page 116
Replacing the Management Ethernet Cable on the SRX5400 Services Gateway on
page 118
Replacing the SRX5400 Services Gateway Console or Auxiliary Cable on page 119
When removing or inserting the SCB, ensure that the cards or blank panels in adjacent
slots are fully inserted to avoid hitting them with the ejector handles. The ejector
handles require that all adjacent components be completely inserted so the ejector
handles do not hit them, which could result in damage.
The ejector handles must be stored toward the center of the board. Ensure the long
ends of the ejectors located at both the right and left ends of the board are horizontal
and pressed as far as possible toward the center of the board.
To insert or remove the SCB, slide the ejector across the SCB horizontally, rotate it,
and slide it again another quarter of a turn. Turn the ejector again and repeat as
necessary. Utilize the indexing feature to maximize leverage and to avoid hitting any
adjacent components.
Operate both ejector handles simultaneously. The insertion force on the SCB is too
great for one ejector.
Taking the SRX5400 Services Gateway Host Subsystem Offline on page 112
Removing the SRX5400 Services Gateway SCB on page 114
Installing an SRX5400 Services Gateway SCB on page 114
Replacing the SRX5400 Services Gateway Routing Engine on page 116
Replacing the Management Ethernet Cable on the SRX5400 Services Gateway on
page 118
Replacing the SRX5400 Services Gateway Console or Auxiliary Cable on page 119
Before replacing the SCB, read the guidelines in
Services Gateway SCB Ejectors" on page
procedures:
Removing the SRX5400 Services Gateway SCB on page 114
1.
Installing an SRX5400 Services Gateway SCB on page 114
2.
Chapter 13: Replacing SRX5400 Services Gateway Hardware Components
"Operating and Positioning the SRX5400
113. To replace the SCB, perform the following
113