Removing The Fan Tray Before Installing An Srx5400 Services Gateway Without A Lift; Removing Cards Before Installing An Srx5400 Services Gateway Without A Lift - Juniper SRX5400 Hardware Manual
Services gateway
Hide thumbs
Also See for SRX5400:
- Hardware manual (406 pages) ,
- Reference (109 pages) ,
- Manual (102 pages)
Table of Contents
Advertisement
185
Removing the Fan Tray Before Installing an SRX5400 Services Gateway Without a Lift
To remove the fan tray (see
Figure 75 on page 185
):
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Loosen the captive screws on the fan tray faceplate.
3. Grasp the fan tray handle and pull it out approximately 1 to 3 inches.
4. Press the latch located on the inside of the fan tray to release it from the chassis.
5. Place one hand under the fan tray to support it and pull the fan tray completely out of the chassis.
Figure 75: Removing the Fan Tray
Removing Cards Before Installing an SRX5400 Services Gateway Without a Lift
The services gateway holds up to four cards (MPCs, SCB, and SPCs), which are installed horizontally in the
front of the device. Each card weighs up to 18.3 lb (8.3 kg), be prepared to accept its full weight.
Advertisement
Table of Contents
Troubleshooting
