Removing Fan Trays Before Installing The Srx5800 Services Gateway; Chassis; Removing Cards Before Installing The Srx5800 Services Gateway - Juniper SRX5800 Hardware Manual

SRX5800 Services Gateway Hardware Guide
Removing the Power Supplies Before Installing the SRX5800 Services Gateway Chassis
70

Removing Fan Trays Before Installing the SRX5800 Services Gateway

3.
Chassis on page 72
Removing Cards Before Installing the SRX5800 Services Gateway Chassis on page 74
4.
Remove the leftmost power supply first and then work your way to the right. To remove
each AC or DC power supply (see
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
1.
ESD points on the chassis.
Switch off the services gateway power supplies:
2.
For an AC-powered services gateway, move the AC input switch on the chassis
above each AC power supply to the off (
equipped with high-capacity AC power supplies, you must also move the AC input
switch on each power supply to the off (
For DC-powered services gateway, move the DC circuit breaker on each power
supply faceplate to the off (
We recommend switching off the power supplies even though they are not connected
to power sources.
While grasping the handle on the power supply faceplate with one hand, use your
3.
other hand to pull the spring-loaded locking pin in the release lever away from the
chassis and turn the release lever counterclockwise until it stops.
Let go of the locking pin in the release lever. Ensure that the pin is seated inside the
4.
corresponding hole in the chassis.
Pull the power supply straight out of the chassis.
5.
WARNING: Do not touch the power connector on the top of the power
supply. It can contain dangerous voltages.
Figure 31 on page 71):
O ) position. If the services gateway is
) position.
O
O ) position.
Copyright © 2014, Juniper Networks, Inc.