Wireless Device Programming; Learning Wireless Sensors - Interlogix ATSx500A Series Installation And Programming Manual

Chapter 3: System functions

Wireless device programming

To add a wireless device, follow one of the following procedures.

Learning wireless sensors

There are two modes available for learning a wireless device, sequential and
manual.
Sequential mode
In sequential mode, you can quickly learn a range of wireless sensors.
To learn sensors in sequential mode:
1. Go to the "4.1.0 Add zone" menu described on page 171.
1>Expander 1
2 Expander 2
2. Select zone location.
Learn mode
>Sequential<
3. Choose Sequential mode and press Enter.
INFO
Tamper RF 1
4. Activate the wireless device. See "Device activation" on page 97 for more
information about activation.
If an error occurs, the keypad shows an error message and beeps seven times.
Example:
ERROR
RF duplicate
The error can occur, for example, when you try to learn a device, which is
already programmed in the wireless expander.
If the device is programmed successfully, the keypad beeps twice.
If there are more wireless devices to program, and the consecutive wireless
zones are available in the wireless expander, repeat activating another wireless
device.
INFO
Tamper RF 2
To stop the learning process and exit the menu, press Clear.
92 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual