Interlogix ATSx500A Series Installation And Programming Manual page 158

Chapter 5: Menu reference
2.2.2.n.4.2 Tamper area
2>Tamper area
Area 1
The Tamper area option determines which area receives expander tamper and
fault events. To change it, press Enter and select the area.
2.2.2.n.4.3 Isolate expander
3 Isolate exp
>No<
Use the Isolate expander command to isolate the tamper fault events on the
selected expander. The expander however remains functional.
2.2.2.n.4.4 Input mode
4 Input mode
>Dual loop<
The Input mode option determines the configuration of zone inputs in the
expander. This setting is similar to the panel zone input mode, which is described
in "8.6.1 Input mode" on page 248.
See "Zone connection" on page 23 for more details on EOL usage.
2.2.2.n.4.5 EOL
5 EOL
>4k7<
The End of line resistor menu allows you to define an end-of-line resistor value
for expander zone inputs. This setting is similar to the panel zone input EOL,
which is described in "8.6.2 EOL" on page 248.
See "Zone connection" on page 23 for more details on EOL usage.
2.2.2.n.5 Expander menu
5>Expander menu
>>>
The menu provides an access to the programming menu built-in to the expander.
For more information, see the appropriate expander manual.
Note:
This menu is not available in wireless expanders ATS1235 with firmware
version 1.13 and newer.
2.2.2.n.6 Delete expander
6 Delete exp.
>Cancel<
Use the Delete expander command to remove an expander. Press Enter, select
OK and press Enter again. The expander is deleted.
152 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual