Device Activation - Interlogix ATSx500A Series Installation And Programming Manual

If 1 zone is selected, this zone functionality depends on sensor configuration.
See "4.1.n.7.5 Sensor opt" on page 184.
If 2 zones are selected, the device must occupy two consecutive zones.
If the second zone has been already programmed, there is an error displayed.
ERROR
Not possible

Device activation

Depending on the device type, the learning activation of this device can differ.
Table 19 below lists all compatible devices and their activation methods.
Table 19: Wireless device learning activation
Device type Learning activation
Door / window Raise a tamper alarm by opening the housing.
sensor
Note:
input must be in open state.
Shock sensor Raise a tamper alarm by opening the housing.
Note:
must be enabled and closed with the magnet.
Smoke detector Raise a tamper alarm by removing the detector head from the base.
PIR camera Raise a tamper alarm by removing the PIR camera from its mounting plate.
Fob 1. Press the unlock button quickly two times, then press and hold until fob
2. Press the unlock button quickly, then press and hold until fob LED
3. Press and hold the unlock button until touchpad light flashes once, and
See the appropriate wireless device manual for more information about the
device functionality.
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
For two zones programming in sequential mode, the external contact
For two zones programming in sequential mode, the reed contact
LED flashes 3 times. Release the button immediately after third flash.
flashes 2 times. Release the button immediately after the second flash.
then release the button immediately.
Chapter 3: System functions
97