Interlogix ATSx500A Series Installation And Programming Manual page 285

The SMS reports and unrecognized SMS commands have two separate
counters. However, the maximum limit defined in this menu is the same for both
counters.
There is no limit for messages if this value is set to 0.
9.3.n.6.4 SMS header msg
4 SMS header msg
> <
The SMS header message identifies the Advisor Advanced system. It is included
at the beginning of each text SMS message sent by the system, if the reporting
format is set to SMS text. See "9.1.n.3 Protocol" on page 259
9.3.n.6.5 User PIN req.
5 User PIN req.
>No<
If the User PIN required option is set to Yes, you must start every SMS control
message with your PIN, otherwise the command will be rejected. See the Advisor
Advanced SMS Control Reference Manual for more information.
9.3.n.6.6 Ext.charset
6 Ext.charset
>No<
The Extended charset (UCS2) option has an influence on the SMS messages
sent by the Advisor Advanced system to the user. This option must be set to Yes
prior to read SMS reports and responses with special and national characters
that exceed the standard GSM charset GSM3.38.
Notes
• The extended charset is used only if there is no possibility to send the
message in the standard charset.
• Older cell phones may not correctly display messages that use the extended
charset.
9.3.n.7 GPRS Setup
1 APN
None
The GPRS Setup menu lets you change various GPRS settings.
9.3.n.7.1 APN
1 APN
> <
The Access Point Name is a configurable network identifier used by a mobile
device when connecting to a GSM carrier. It must be specified by the GPRS
provider.
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Chapter 5: Menu reference
279