Quick Programming - Interlogix ATSx500A Series Installation And Programming Manual

Chapter 1: Quick installation and programming

Quick programming

Initial start-up
Note:
See "The Advisor Advanced menu"
on page 106 for menu explanation. For
more information on editing options, see
"How to program the options" on page 108.
Switch the panel on. The further messages
and menus are listed in the table below.
Display
INFO
Inst required
1>Panel language
2>Defaults
4>PIN length
5>Time&date
6 Install
>Cancel<
Installer
PIN:127800
Supervisor
PIN:112200
The panel restarts.
Auto configuration
Auto Config?
>Yes<
Rkp 1-16 BUS1
R-?-------------
Exp 1-15 BUS1
-?-------------
Added
R:1 D:0 Z:8
Enabling service in
UTC F&S
THU 05 Mar 12:21
4
Instructions
Press Enter to continue.
Choose English.
Choose EN 50131 Grade 3.
Enter 6.
Set current time and date.
Choose OK
Press Enter to continue.
Press Enter to continue.
Press Enter to continue.
Wait until the panel
configures all bus devices
and zones.
Press Enter to continue.
Press 112200, Menu
1>Zone options
2 Isolate
8>Service in
Enable?
Press Cancel, Cancel to log off.
Programming menu entry
UTC F&S
THU 05 Mar 12:21
Inh reports
>No<
Inh tampers
Unset areas
1>Service menu
2 Device menu
The installer menu is displayed.
Changing installer PIN
Go to 3.1.n.2.1 Change PIN (see page 163).
1>Change PIN
***********
New PIN
>_
Configuring zones
Go to 4.1 Zone menu (see page 171).
4>Zones&Areas
1>Zone menu
0>Add zone
1 Zone 1
For each zone used in the system, enter
zone name in 4.1.n.1 Zone name (page
172).
01 Zone name
>1 Zone 1
Next, set its zone type in 4.1.n.2 Zone type
(see page 172).
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Go to menu 8.8 Service in
Enable Installer in time
Press 127800, Menu
Press Enter to continue.
Press Enter.
Enter the new installer PIN.
Press Enter.
Press Enter.
Select a zone.
<