Siren Connection; Other Connections - Interlogix ATSx500A Series Installation And Programming Manual

Chapter 2: Installation

Siren connection

Figure 20: Siren connection examples
S4 S5 S1 C S2 C
LC-OUTPUTS HC-OUTPUTS
(1) (1)
(2) (2)
(1) Siren EOL resistor (1 kΩ). It must be
installed if siren does not contain a
built-in resistor.
(2) Siren.
Note: Siren output can be configured as internal or external. This is accomplished via panel
settings, not by configuring the panel hardware. See "Default output assignments" on page 31
and "Outputs" on page 67.

Other connections

Tamper connection
Figure 21: Earthing and tamper connection in ATSx500A(-IP)
PSTN connection
To connect PSTN in ATSx500A(-IP) control panels, use ATS7700 PSTN module.
See ATS7700 PSTN Module Installation Sheet for details.
Caution: If the PSTN line is provided via the ADSL network, make sure that at
least ADSL splitter/filter is used, otherwise the PSTN communication quality may
be too low for a reliable reporting.
28
S3 C
- -
T C
SIR TMP AUX POWER
(4)
(1)
(2)
(5)
( ) 1
( ) 2
( ) 3
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
S4 S5 S1 C S2 C
LC-OUTPUTS HC-OUTPUTS
(1) (1)
(2) (2)
(3) Beacon.
(4) Siren tamper EOL resistor.
(5) Siren tamper (normally closed).
(1) Earthing
(2) External tamper (normally closed)
(3) Optional pry-off tamper (normally
closed) required by EN 50131
Grade 3 and VdS-C regulations
S3 C
- -
T C
SIR TMP AUX POWER
(4)
(5)
(3)