If next zones are already occupied on the wireless expander, the learning
process is over.
Proceed with the zone configuration.
Manual mode
In manual mode, you can learn and configure a wireless sensor.
To learn a sensor in manual mode:
1. Go to the "4.1.0 Add zone" menu described on page 171.
1>Expander 1
2 Expander 2
2. Select zone location.
Learn mode
>Manual<
3. Choose Manual mode and press Enter.
Tamper RF 1
Press # for ID
4. Activate the device, or press Enter to enter the wireless device identifier
manually. See "Device activation" on page 97 for more information about
activation.
Sensor ID
>
Note:
Learning a wireless PIR camera by entering its identifier is not
supported.
The sensor ID is printed on a barcode sticker on the sensor box in the
following format: "Tx H<nnnnnnn>". For example, "Tx H103EB2B" mark
identifies a sensor with the ID 103EB2B. See also "4.1.n.7.1 Sensor ID" on
page 183 for more details on sensor identification.
If the input has been already programmed, you are informed by a message and
seven beeps.
INFO
RF exists
Next you are asked if you want to replace the programmed wireless device.
Replace RF dev?
>No<
Note:
If the programmed device has two inputs capacity, the system asks should
the device occupy two zones. See "Two-zone RF sensors" on page 96.
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
<
Chapter 3: System functions
93