Interlogix ATSx500A Series Installation And Programming Manual page 96

Chapter 3: System functions
Type Description
Test pic to CS Take a picture and send it to a
central station
Fire Raise a fire alarm
Medical alarm Raise a medical alarm
Show inhibited Show inhibited zones
GSM credit Check GSM credit
UG area access Change user access to areas
Prohibit unset Disable area unset
Shunt Allow shunt in areas
Show shunted Show shunted zones
Show isolated Show isolated zones, keypads,
and expanders
Unlocked Unlock doors
RTE Enable Request To Exit input
for specific doors
Low security Enable Low security mode for
specific doors
Access enabled Enable access to doors in a
door group [6]
[1] Depending on system settings, the function may require logging in of a user with the
appropriate privileges. See "2.2.1.n.3.11 Quick set" on page 147 for more details.
[2] Set and part set function start time is the time when the warning timer is started. The warning
time must be taken into account. See "4.2.n.4.1 Warning time" on page 187 for more details.
[3] The function is an entry to the appropriate user menu. See Advisor Advanced Manager
Manual for more details.
[4] The function requires logging in of the supervisor or the installer.
[5] The function requires logging in of the supervisor.
[6] Caution: This function should be only performed in a time frame with specified end time. See
also Chapter 3 "System functions > Counteractions" on page 78.
The described functions can be activated by one of the following:
• Schedule. See "Calendar" on page 77 for more details.
• Function key. See "Function keys" on page 57.
• Fob. See "Wireless device programming" on page 92 for more details.
90
Available parameters
1. Camera
2. Central station
None
None
None
None
1. UG identifier
2. Areas selection
3. Area groups selection
1. Areas selection
2. State change: On or Off
1. Areas selection
2. State change: Shunt, Unshunt, Toggle
None
None
1. Door selection
1. Door selection
1. Door selection
1. Door group selection
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual