Interlogix ATSx500A Series Installation And Programming Manual page 238

Chapter 5: Menu reference
8 System option menu
1>Timer menu
2 Engineer opt
Use the System menu to program the global system options including timers.
8.1 Timer menu
1>Time&date
2 Siren options
Use the Timer menu to program all system wide timers in this section.
Notes
• Timers are accurate to ±1 of the value entered. So a timer set for 20 seconds,
ends somewhere between 19 and 21 seconds. Consequently, avoid using
values of 1 second or 1 minute.
• If a timer is set to 0, that timer is not used.
8.1.1 Time and date
1>Time zone
UTC+1
The Time and date menu allows you to set the system time and date, as well as
set up daylight saving time.
The following options are available.
• 1 Time zone. The system time zone.
• 2 Date. Date format is DD-MM-YYYY.
• 3 Time. Time format is 24 hours.
• 4 DST start mth. The DST start month.
• 5 DST start wk. The DST start week. The available options are: 1st week, 2nd
week, 3rd week, 4th week, last week.
• 6 DST end mth. See above.
• 7 DST end wk. See above.
• 8 Set correction. Allows configuring time correction if necessary.
- 8.1 Time/7days. This submenu allows setting the time correction that is
performed each 7 days of panel work.
Maximum value is 5 min 40 s. Positive value means the clock is set forward,
negative — backward.
232 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual