the "9.1 Central station" menu. See "9.1.n.4.3 Ping host" on page 264 for more
details. See also "1.2.7.n.2 Ping host" on page 132.
1.2.7.n.5 NTP status
5>NTP status
Inactive
The NTP status screen allows you to check the current status of the Network
Time Protocol server configured. Possible server statuses are listed below.
•
Inactive: The NTP server is not queried yet. This status is usually present
after panel restart or NTP configuration.
•
Unknown: The query was sent, but no answer from NTP server was received
yet.
•
Fail: No answer from NTP server.
•
OK: NTP server answered the query.
•
Link error: Faulty Ethernet line.
1.2.8 GSM diagnostic
1>PIN status
Normal
The GSM diagnostic menu provides an access to diagnostic tools for GPRS and
SMS connectivity.
1.2.8.1 PIN status
1>PIN status
Normal
The PIN status is an informational screen that lets you verify the PIN acceptance
status. The status can be one of the following:
•
Normal: Accepted by the SIM.
•
Unknown: The status is unknown.
•
One trial left! The SIM card provides the last attempt for the correct PIN.
•
PUK required! The SIM card is locked after three unsuccessful PIN entering
attempts, until the PUK will be provided.
You can only unlock the SIM card by inserting it in a standard cell phone and
providing the PUK. There is no possibility to enter the PUK in the Advisor
Advanced system.
1.2.8.3 GSM net.reg.
3>GSM net.reg.
Home network
The GSM network registration state can be one of the following:
•
Inactive: The dialler has not registered in the network, and is not searching
nor connecting
•
Home network: Registered in the home network
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Chapter 5: Menu reference
133