•
6 Interconnection fault: A critical error caused by communication trouble
between internal panel components
•
7 Mains fault: Mains fault, including external fault
•
8 Battery fault: Battery fault, including external fault
•
9 FTC (Failed to Communicate): Alarm reporting has failed to deliver events
•
10 Siren fault: Siren output fault
•
11 Zone technical: Technical zone status
•
12 Keypad fault: A fault reported by keypad
•
13 Expander fault: A fault reported by remote expander
•
14 Comms fault: All transmission paths are down (no communication)
•
15 Engineer reset: Engineer reset requirement
•
16 Alarms pending: Unacknowledged alarms
8.4.2 Inhibit includes
1>Zone panic
Access level 3
The menu defines which conditions a user with particular access level is allowed
to inhibit. If a particular condition below has this option set to Access level 2 or
Access level 3, a user with this access level can inhibit it using an inhibit menu or
during set.
The following options are available.
•
1 Zone panic: Holdup device active
•
2 Zone masking: Masking / fault state on input
•
3 Zone fault: Intrusion detector fault
•
4 Zone tamper: Tamper in zone
•
5 Interconnection fault: A critical error caused by communication trouble
between internal panel components
•
6 Mains fault: Mains fault, including external fault
•
7 Battery fault: Battery fault, including external fault
•
8 FTC (Failed to Communicate): Reporting attempts are failed
•
9 Siren fault: Siren output fault
•
10 Zone technical: Technical zone status
•
11 Keypad fault: A fault reported by keypad
•
12 Expander fault: A fault reported by remote expander
•
13 Comms fault: All transmission paths are down (no communication)
•
14 Engineer reset: Engineer reset requirement
8.4.3 Part set
1>Report BA
Yes
The Part set menu allows you to configure the part set options.
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Chapter 5: Menu reference
243