Interlogix ATSx500A Series Installation And Programming Manual page 268

Chapter 5: Menu reference
9.1.n.8.1.5 SIA frequency
5 SIA frequency
>Bell<
The SIA frequency menu allows you to select one of two standards for modem
communication regarding transmitted/received frequencies used by
transmitter/receiver.
This option allows you to select between CCITT and BELL.
9.1.n.8.2 VOICE
1>Suppress FTC
No
The VOICE menu allows you to configure voice reporting options listed below.
9.1.n.8.2.1 Suppress FTC
1 Suppress FTC
>No<
If the Suppress FTC option is set to Yes, no FTC fault is activated for this central
station when the voice protocol is used.
9.1.n.8.2.2 Without ACK
2 Without ACK
>No<
If the Without ACK option is set to Yes, a recipient of a voice message does not
need to acknowledge the message.
Otherwise, he must acknowledge it by pressing a phone key using tone dialing
mode. The panel tries to retransmit the message until it is acknowledged.
9.1.n.9 OP/CL report
9 OP/CL report
>Separate<
The OP/CL report option defines if opening and closing is reported for all areas
with the same account code, or for each of those. The following options are
available:
• Combined: When all areas with the same account code are armed, a closing
is reported using the area and user who armed it. An opening is reported only
when the first of the areas with the same account code is disarmed.
• Separate: For any of areas with the same account code a closing and an
opening is reported. The area modifier indicates the area concerned (see
"9.1.n.8.1.1 Area modifier" on page 261).
Note:
When (X)SIA protocol is selected, separate reporting works only when SIA
area modifier is enabled.
See "9.1.n.5 Accounts" on page 259 for more details.
262 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual