Interlogix ATSx500A Series Installation And Programming Manual page 278

Chapter 5: Menu reference
menu below. If this option is set to Dynamic, the DHCP is used to obtain the DNS
IP address.
If DHCP is disabled, this menu is not available.
9.3.n.5.2 DNS server
2 DNS server
>000.000.000.00<
The DNS server menu allows you to set the DNS address if it is different from the
DNS provided by DHCP server, or if DHCP is disabled in menu "9.3.n.4.1 IP
config" menu on page 271.
9.3.n.6 NTP config
6 NTP config
>Static<
The NTP config menu is used to configure the NTP (Network Time Protocol)
server.
The following options are configurable in this menu.
9.3.n.6.1 NTP config
1 NTP config
>Static<
If the IP configuration in menu "9.3.n.4 IP config" on page 270 is set to Dynamic
(DHCP is enabled), you can set the NTP configuration option to Static to override
the automatic NTP configuration by DHCP server. Set the NTP address in the
menu below. If this option is set to Dynamic, the DHCP is used to obtain the NTP
IP address.
If DHCP is disabled, this menu is not available.
9.3.n.6.2 NTP server
2 NTP server
>000.000.000.00<
The NTP server menu allows you to set the NTP address if it is different from the
NTP provided by DHCP server, or if DHCP is disabled in menu "9.3.n.4.1 IP
config" menu on page 271.
9.3.n.7 Firewall
1>Firewall
On
The Firewall menu is used to configure the built-in firewall. The firewall allows
only communication from hosts that are configured as appropriate PC
connections in "9.4.1.n.4 Destination/IP" on page 285.
The following options are configurable in this menu.
272 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual