Interlogix ATSx500A Series Installation And Programming Manual page 137

1.2.6.n.3 Period
3 Period
> <
The Period menu defines an interval for test calls that are described in "1.2.6.n.2
Test call time" on page 130.
The allowed range is 1 to 999 hours.
1.2.6.n.4 Extend
4 Extend
>No<
The Extend option defines whether the test call interval is counted from the
previous test call or from the last successful event report.
If this option is set to Yes, after an event transmitted to the central station the test
call delay is extended and the next test call is postponed.
If this option is set to No, the next test call occurs in a test call period after the
previous test call, regardless of other reported events.
1.2.6.n.5 Freq TC if FTC
5 Freq TC if FTC
>No<
If this option is set to Yes, during the communication fault (FTC) the panel tries to
establish a communication by initiating a test call every hour. Otherwise, the test
call is attempted as usual.
1.2.6.n.6 Man. test call
Calling CS 1...
Ready
The Manual test call option lets you test the central station reporting. Select the
central station. The panel now tries to establish a connection with the selected
central station.
The call progress status is shown on the display.
1.2.7 IP diagnostic
1>ETH
>>>
The IP diagnostic menu provides an access to diagnostic tools for IP
connectivity.
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Chapter 5: Menu reference
131