Interlogix ATSx500A Series Installation And Programming Manual page 95

Type Description
Part set 2 Part set 2 for areas [1][2]
Inhibit Inhibit zones [1][3]
Test call Execute a test call [3][4]
PC connection Establish connection with the
PC [1][3]
Service in Allow service in [5]
Panic Activate panic alarm
Chime area Change a chime functionality
status in the area
Chime keypad Change a chime functionality
status on the keypad
Set without exit Immediate set (without exit
time) [1]
Fire reset Reset fire detectors [1]
Show open zones Show open zones [1]
Active alarms Show zones in alarm state [1]
Active faults Show faulty zones [1]
Alarm memory Show acknowledged alarms [1] 1. User code requirement
Alarms to ACK Show unacknowledged alarms
[1]
UG control Change user group privileges
Keypad control Change keypad options
Walk test Run walk test [1]
Output test Test outputs [1][4]
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Chapter 3: System functions
Available parameters
1. Areas selection
2. User code requirement
None
None
None
None
None
1. Areas selection
2. Status change: Clear, Set, or Toggle
1. Keypad selection
2. Status change: Clear, Set, or Toggle
1. Areas selection
2. Area groups selection
3. User code requirement
1. Areas selection
1. User code requirement
1. User code requirement
1. User code requirement
None
1. UG identifier
2 and further - user group privilege.
Choose a privilege, and then change it.
See "3.2.n.6 User group options" on page
169 for more details.
Note that the user group type must allow
this change. See "3.2.n.2 User group type"
on page 168 for details.
1. Keypad identifier
2. State change: lock or unlock
1. Area selection
1. Output selection.
4 outputs can be assigned.
These outputs are switched on
simultaneously for the longest time period
configured in "8.1.2.1 Activation" on page
233.
2. User code requirement.
89