Interlogix ATSx500A Series Installation And Programming Manual page 317

Appendix A
Advisor Advanced events
For Advisor Advanced system events, see Table 31 below. For access control
events, used to program door controllers, see Table 32 on page 322.
Table 31: Advisor Advanced events
Group Event
Zone ACTIVE
TAMPER
AM
BATTFAULT
FAULT
DIRTY
SVSHORT
SVLONG
INHIBIT
ISOLATE
SOAK
SET
ALARM
RF learned
RF signal accept
Held Open
Inactive days
SHUNT
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
# Event description
1 Zone active
2 Zone tamper
3 Zone masking
4 Zone battery fault
5 Zone fault
6 Zone dirty
7 Zone supervision
short
8 Zone supervision
long
9 Zone inhibited
10 Zone isolated
11 Zone in soak test
12 Zone set
13 Zone in alarm
14 Wireless device
programmed
15 Wireless device
found
16 Zone is open too
long
17 Zone inverted walk
test failed
18 Zone shunted
Notes
Zone in active state
Zone in tamper state
Zone in anti-mask alarm state
Zone in battery fault state
Zone in fault state
Zone in dirty state
Zone in short supervision state
Zone in short supervision state
Zone state changed to inhibited
Zone state changed to isolated
Soak test is active
Zone in Part set or Full set mode
Zone in alarm. Restores after
alarm acknowledgement.
Active for 3 seconds after a
successful programming
Active for 3 seconds after device
response
Zone is held open
Zone has been inactive for
longer than inactive day limit
311