Table of Contents
Advertisement
Chapter 3: System functions
Using cameras
A wireless PIR camera is a wireless PIR detector with a camera built-in. The
camera can be programmed to take pictures in case of activation of associated
zones, conditional filters, as well as by manual activation or remote requests.
After an alarm the associated pictures are sent to a central station via IP/GPRS.
Pictures can also be viewed from configuration software.
Configuration
The system with a wireless PIR camera expander can have up to 8 wireless PIR
cameras programmed. Each camera can be activated in case of the following
events:
•
Activation of one of 4 assigned zones. Zones are assigned in menu "4.5.n.2
Pics by zone" on page 193.
In this case camera event type depends on the zone type. See "Camera
event types" below.
See also "Zone types" on page 45.
•
Activation of a condition filter. The event type is defined for the programmed
filter. See "4.5 Cameras" on page 193.
•
Activation of a standard reporting event. See "4.5.n.4 Pics by rep ev" on page
194.
•
User command.
•
Remote request from configuration software.
The number and the quality of pictures taken depend on the camera event type.
Camera event types
There are the following camera event types available.
•
Burglar alarm. Generated by alarm, entry/exit, access, 24 H, fire door and
keybox type zones.
•
Fire alarm. Generated by fire zones.
•
Panic alarm. Generated by panic zones.
•
Medical alarm. Generated by medical zones.
•
Tamper alarm. Generated by tamper zones.
•
Fault. Generated by technical, transmission fault, aux mains fault and aux
battery fault type zones.
•
Custom type 1. Generated by conditional filters of this type.
The types are assigned to conditional filters in "4.5.n.3.m.2 Event type <n>"
on page 194.
•
Custom type 2. Generated by conditional filters of this type.
98
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
