Interlogix ATSx500A Series Installation And Programming Manual page 166

Chapter 5: Menu reference
2.2.3 DC/LC Exp Rdrs
0>Add reader
1 Reader 1
Keypads and readers, connected to one of door controller local buses, can be
configured as intelligent system readers to provide access control functions.
Press 0 to add a reader, or a number to configure an existing one.
Note:
The maximum number of devices allowed on the databus is given in
"General features" on page 36.
Reader options
2.2.3.0 Add reader
Reader number
>_<
On the Add reader menu, enter the number for this new reader and press Enter
to confirm or Clear to exit without adding a device.
After the device is added, the reader configuration options are shown.
2.2.3.n Select reader
Select the reader number to configure.
2.2.3.n.2 Reader address
2>Reader address
Exp: 1 ADDR: 0
The information screen showing the reader address. The address is set by DIP
switches or programmed within the keypad or reader menu.
2.2.3.n.3 Reader options
1>Reader name
Reader 1
The Reader options menu contains the shown below, which are necessary to
configure the selected Reader.
2.2.3.n.3.1 Reader name
1 Reader name
>Reader 1<
Use the Reader name option to enter a name that identifies the reader to the
end-user.
When a reader is created, it is given the default name "Reader <n>", where <n>
is the Reader number. Enter this menu to edit the current name.
A reader name can consist of 16 characters.
160 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual