Interlogix ATSx500A Series Installation And Programming Manual page 321

Group Event
WALK
WALKZNACTV
A-ALARM
B-ALARM
ISIREN
ESIREN
STROBE
BUZZER
AMRESET
PARTSET2
AS_WARNING
AUTO_SET
HA-ALARM
HB-ALARM
ZNINH LIMIT
ZNISOL LIMIT
ZNSHT LIMIT
ZNISOL FAULT
UNSETDELAY
UNSETTIME
UNSETWARNTIME
UNSETEXTTIME
AREA DSHUNT
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
# Event description
67 Walk test
68 Walk test zone
active
69 A-Alarm
70 B-Alarm
71 Internal siren
72 External siren
73 Strobe output
74 Buzzer output
75 AM reset
76 Area part set 2
77 Autoset warning
78 Autoset
79 A hold-up alarm
80 B hold-up alarm
81 Inhibit limit
82 Isolation limit
83 Shunt limit
84 Faulty zone
isolated
85 ATM unset delay
86 ATM unset time
87 ATM unset warning
time
88 ATM extended
unset time
89 Door shunt
Appendix A: Advisor Advanced events
Notes
User/Installer Walk test is active
Zone in walk test is activated
A-alarm active (unconfirmed
alarm), reset after unset or
expiration of AB timer and no B-
alarm.
B-alarm active (confirmed
alarm). Reset after unset
Internal siren. Activated on
alarm during the internal siren
time. Activation may be delayed
by Siren delay time.
Can be retriggered by next
alarm.
External siren. Activated on
alarm during the external siren
time. Activation may be delayed
by Siren delay time.
This flag can not be retriggered.
Strobe output. Activated by
alarm during Set. Deactivated
after unset.
Buzzer output flag
Activated during set procedure
to reset AM detectors
Area is in part set 2 state.
Area in warning state prior to
autoset
Autoset procedure is in progress
Reset after unset
Reset after unset
Zone inhibit limit is reached
Zone isolation limit is reached
Zone shunt limit is reached
ATM unset delay is active
ATM unset time is active
ATM unset warning time is
active
Extended ATM unset time is
active
A zone in the area is shunted
315