Interlogix ATSx500A Series Installation And Programming Manual page 151

• You cannot select an area to view and control using this option, if this area is
assigned to a door. To do so, use the menu "5.1.n.6.3 Alarm control" on page
199 instead.
2.2.1.n.3.4 View AG
01-10>View AG
12.4......
Provides the same functionality as in "2.2.1.n.3.3 View areas" on page 144, but
for area groups.
See also "Area groups" on page 50.
2.2.1.n.3.5 Control areas
5>Control areas
12.4....
The Control areas menu allows you to select areas that can be controlled by this
keypad. The areas are displayed as a list. To change the selection, press Enter
or Right, and select the appropriate areas.
See also "2.2.1.n.3.3 View areas" on page 144.
2.2.1.n.3.6 Control AG
01-10>Control AG
12.4......
Provides the same functionality as in "2.2.1.n.3.5 Control areas" above, but for
area groups.
See also "Area groups" on page 50.
2.2.1.n.3.7 Control options
1>Card&PIN mode
Card or PIN
The menu contains a set of options connected to the selected keypad control
functions.
See also "Keys" on page 54.
2.2.1.n.3.7.1 Card&PIN mode
1 Card&PIN mode
>Card or PIN<
The Card and PIN mode option allows you to select one of the following control
methods.
• PIN only: Only the PIN is necessary to set and unset areas
• Card only: A single card badge unsets areas
• Card and PIN unset: Both card and PIN are required to unset areas
• Card and PIN always: Both card and PIN are required to set or unset areas
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Chapter 5: Menu reference
145