Loading Factory Defaults (Device 191) - Interlogix NX-595E Installation Manual

on the same subnet as our computer and that the IP address is not used
by another device.
d. Put the NX-595E into program mode by using a keypad and enter device
191. By default this is an extra layer of security to prevent unauthorised
remote access. Then try again from a web browser. You can also enable
web access permanently on the NX-595E in Location 19, Segment 1,
Option 6 = On
e. While the NX-595E is in program mode: On a windows computer, click
Run, type cmd, press Enter, then ping [ip address]. If there is an
error it will show "timed out" and you should check your network. If you
see a time then your computer can talk to the NX-595E. You can also
enable ping permanently on the NX-595E in Location 19, Segment 1,
Option 4 = On.
2. I'm not receiving any emails!
a. Perform testing using a standard user PIN, the installer account by default
does not send all reports.
b. Check that the emails are not being captured in your SPAM folder or
blocked by a firewall.
c. Check the email address is correct.
d. Check that the event is ticked in the NX-595E settings.
e. Check that you are receiving other emails.
f. Check that the relevant reporting options are enabled in the panel
programming.
g. Try using xConnect app to verify your system is connecting to the servers

Loading Factory Defaults (device 191)

The NX-595E is automatically set to device number 191, and programming is
carried out like all other NetworX modules. The following examples show how to
access the programming of the NX-595E via a standard keypad or a NX-181xx
Voice keypad. The NX-595E will require defaulting the first time it is accessed by
entering [9][1][0][#] or [9][1][0] [ENTER] depending on the keypad type. This will
only be required once.
NX-595E Installation Manual 17