How To Program The Options; Accessing The Installer Programming Menu - Interlogix ATSx500A Series Installation And Programming Manual

Chapter 4: Programming

How to program the options

Accessing the installer programming menu

The Advisor Advanced system is programmed from the installer programming
menu. Before accessing the programming menu, the system administrator must
unset the system. Depending on the system settings, you also can be prompted
to open the panel housing prior to configuring the system.
How to access the installer programming menu
1. Start with this LCD display:
UTC F&S
TUE 27 May 10:00
2. If the option "8.2.1 User code required" (see page 237) is set to Yes, the
engineer access must be granted by the manager first. The manager must log
in, activate the "Service In" option, and logout. Now the installer can login
within the time period defined in "8.1.3.6 Installer in-time" on page 235.
3. Press Menu. The display shows:
Enter card/code
>_
4. Enter your PIN and then press Enter.
Alternatively and if configured you may also present a card to the reader.
The following display appears:
Inh reports
>Yes<
5. Select Yes if you want to inhibit all reports during system programming.
Reports include reporting to central station as well as reporting events in the
logs.
6. Press Enter. The next screen shows whether tampers are inhibited and areas
are unset:
Inh tampers
Unset areas
7. Press Enter again. You are now in the programming menu. The following
display appears:
1>Service menu
2 Device menu
108 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual