Suzuki WagonR+ RB310 Service Manual page 2576

Pipe
Quick
joint
1. Clamp
2. Pipe cover
3. Quick joint
FUEL LINES
Due to the fact that fuel feed line is under high pressure, use special
care when servicing it.
INSPECTION
Visually inspect fuel lines for evidence of fuel leakage, hose crack
and deterioration, or damage.
Make sure that all clamps are secure.
Replace parts as needed.
FUEL PIPE
REMOVAL
1) Relieve fuel pressure in fuel feed line.
2) Disconnect negative cable at battery.
3) Remove steering gear box assembly. Refer to Section 3B for de-
tails.
4) Remove pipe cover (2) from vehicle.
5) Disconnect fuel pipe joint and fuel hoses from the front end and
the rear end of each fuel pipe.
For quick joint (3), disconnect it as follows:
a) Remove mud, dust and/or foreign material between pipe and
b) Unlock joint lock by inserting special tool between pipe and
Before
disconnecting,
blow off
dust, etc.
of this portion
c) Disconnect joint from pipe.
with compressed
air.
joint by blowing compressed air.
joint.
Special Tool
(A): 09919-47020
WARNING:
A small amount of fuel may be released after fuel hose
is disconnected. In order to reduce the chance of per-
sonal injury, cover hose and pipe to be disconnected
with a shop towel.
Be sure to put that towel in an approved container
when disconnection is completed.
ENGINE FUEL 6C-5