Suzuki WagonR+ RB310 Service Manual page 2623

6E-36 ENGINE AND EMISSION CONTROL SYSTEM
1
Inspection
1) Check resistance between following terminals of EGR valve in
each pair.
1. EGR valve
2. Connector
If found faulty, replace EGR valve assy.
2) Remove carbon from EGR valve gas passage.
2
NOTE:
Do not use any sharp–edged tool to remove carbon.
Be careful not to damage or bend EGR valve, valve seat and
rod.
3
3) Inspect valve, valve seat and rod for fault, cracks, bend or other
damage.
1. EGR valve
2. Valve
If found faulty, replace EGR valve assembly.
3. Valve seat
Installation
Reverse removal procedure noting following.
D Clean mating surface of valve and intake manifold.
D Use new gasket.
Terminal
A – B
C – B
F – E
D – E
Standard resistance
20 – 24 Ω