Suzuki WagonR+ RB310 Service Manual page 2957

8G-22 IMMOBILIZER CONTROL SYSTEM
ON-VEHICLE SERVICE
PRECAUTIONS IN HANDLING IMMOBILIZER
CONTROL SYSTEM
D Do not turn ignition switch to ON position (II) with ignition key with
built-in transponder put together with another one or placed quite
close to another one. Or the system may detect abnormal condi-
tion and prevent engine from running.
D Do not turn ignition switch to ON position (II) by using ignition key
with built-in transponder with any type of metal wound around its
grip (housing) or in contact with it. Or the system may detect ab-
normal condition and prevent engine from starting.
D Do not leave ignition key with built-in transponder where high
temperature is anticipated. High temperature will cause trans-
ponder in ignition key to be abnormal or damaged.
D Do not turn ignition switch to ON position (II) with a radio antenna
placed near coil antenna or its harness to immobilizer control
module.
Or the system may detect abnormal condition and prevent engine
from starting.
IMMOBILIZER CONTROL MODULE
REMOVAL
1) Remove steering column cover.
2) Remove key cylinder cap from key cylinder switch.
3) Turn ignition switch to (I) position.
4) Push the protrusion in the hole.
5) Pull off key cylinder from column ass'y.
6) Disconnect wire harness connector from immobilizer control
module.
7) Remove immobilizer control module.
INSTALLATION
Reverse removal procedure. Before inserting key cylinder to steer-
ing column, push protrusion on key cylinder.