Suzuki WagonR+ RB310 Service Manual page 2728

1, (a), "B"
1, (a), "B"
GEAR SHIFT AND SELECT SHAFT ASSEMBLY
1) Clean mating surface of guide case.
2) Apply grease to select lever shaft bush and select lever washer,
and install gear shift and select shaft assembly with new gasket
into transmission.
"A": Grease A, 99000-25010
3) Apply sealant to gear shift guide case No. 2 bolt (5). Tighten gear
shift guide case No. 1 bolts (1) and No. 2 bolt (5) to specified
torque at the position that clearance "a" is within 1 – 1.5 mm (0.04
– 0.06 in.).
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 17.0 lb-ft)
4) Install washer and gear shift interlock bolt (2) applied with seal-
ant and them tighten it to specified torque.
"B": Sealant, Bond No.1215, 99000-31110
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 17.0 lb-ft)
5) Install washer and 5th to reverse interlock guide bolt (3) applied
with sealant and then tighten it to specified torque.
"B": Sealant, Bond No. 1215, 99000-31110
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 17.0 lb-ft)
6) Tighten back up light switch (4) to specified torque.
Tightening Torque
.
(b): 19 N m (1.9 kg-m, 14.0 lb-ft)
7) Check input shaft for rotation in each gear position.
8) Also confirm function of back up light switch in reverse position
by using ohmmeter.
MANUAL TRANSMISSION 7A-37