Rear Door Window Regulator - Suzuki WagonR+ RB310 Service Manual

7) Remove door sash mounting bolts (1).
8) Remove glass attaching screws (2).
9) Turn door glass (3) 90_.
10) Take out door glass (3).
INSTALLATION
NOTE:
If there is deformity for glass run, replace new one.
Reverse removal procedure to install door glass noting following
points:
D Tighten glass attaching screws (1) to specified torque. Tighten
rear screw first, then front screw.
Tightening Torque: 6 N
D Secure door sealing cover (1) with adhesive (2).
D Install door window regulator handle (1) so that it has a 45° angle
when glass is fully closed, as shown in left figure.

REAR DOOR WINDOW REGULATOR

REMOVAL
1) Remove door glass, referring to steps 1) to 9) of REAR DOOR
GLASS REMOVAL in this section.
2) Loosen regulator mounting nuts (1) and take out regulator
through hole (2) as shown in left figure.
BODY SERVICE 9-9
.
m (0.6 kg-m, 4.3 lb-ft)