Suzuki WagonR+ RB310 Service Manual page 2313

5C-10 PARKING AND REAR BRAKE
3) Put flat head rod or the like between rod (1) and rachet (2) and
pull rachet as shown to maximize clearance between shoe and
drum.
4) Install brake drum after making sure that inside of brake drum
and brake shoes are free from dirt and oil.
5) Install new spindle nut (1).
6) Tighten spindle nut (1) to specified torque.
Tightening Torque
.
(a): 175 N m (17.5 kg-m, 126.5 lb-ft)
7) Calk spindle nut (1).
8) Install spindle cap.
NOTE:
D When installing spindle cap, hammer lightly several loca-
tions on the collar of cap until collar comes closely into
contact with brake drum.
D If fitting part of cap is deformed or damaged or if it is fitted
loosely, replace with new one.
9) Upon completion of all jobs, depress brake pedal with about
30 kg (66 lbs) load three to five times so as to obtain proper
drum-to-shoe clearance.
Adjust parking brake cable. (For adjustment, see PARKING
BRAKE INSPECTION AND ADJUSTMENT in SECTION 5.)
10) Install console box if removed.
11) Install wheel and tighten wheel nuts to specified torque.
Tightening Torque
.
(b): 85 N m (8.5 kg-m, 61.5 lb-ft)
12) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).