Suzuki WagonR+ RB310 Service Manual page 2350

LH
9) Perform the following checks with help of another person.
Brake pedal should be depressed and then ignition switch
turned ON by one person and wheel should be turned by
another person's hand. At this time, check that:
D Operation sound of solenoid is heard and wheel turns only
about 0.5 sec. (Brake force is depressurized).
D Operation sound of pump motor is heard and pulsation is felt
at brake pedal.
10) If all 4-wheels cannot be checked during one ignition cycle
(OFF ! ON), repeat Steps 8) and 9) till all 4 wheels are
checked.
If a faulty condition is found in Steps 9) and 10), replace hydrau-
lic unit/control module assembly.
11) Turn ignition switch "OFF" and remove service wire from moni-
tor coupler.
ABS HYDRAULIC UNIT/CONTROL MODULE
ASSEMBLY
RH
HYDRAULIC UNIT INSPECTION
Check hydraulic unit for fluid leakage.
If any, repair or replace.
ANTILOCK BRAKE SYSTEM (ABS) 5E1-29
CAUTION:
Never disassemble ABS hydraulic
unit / control module assembly, loos-
en blind plug or remove motor.
Performing any of these prohibited
services will affect original perfor-
mance of ABS hydraulic unit / control
module assembly.
Tightening Torque
(a): Brake pipe flare nut
(b): ABS hydraulic unit / control
module assembly support
(c): ABS hydraulic unit / control
module assembly mount bolts
(d): ABS hydraulic unit / control
module assembly bracket bolts 26
1. Brake pipe
2. ABS hydraulic unit / control
module assembly
3. Bracket
4. Connector
.
N m (kg-m, lb-ft)
16 (1.6, 11.5)
9 (0.9, 6.5)
9 (0.9, 6.5)
(2.6, 18.0)