Suzuki WagonR+ RB310 Service Manual page 2250

(A)
8) Place new wheel side small band (1) onto boot putting band
outer end (2) against forward rotation (3) as shown in figure.
9) Confirm that wheel side boot is not stretched or contracted and
fasten boot small band (1) securely at that position.
Special Tool
(A): 09943-55010
10) Install damper (1) on drive shaft according to dimension speci-
fied below. (For M/T model only)
Length "a": 347 – 353 mm (13.7 – 13.9 in.)
11) Set new differential side small band and differential side boot
(1) on shaft temporarily.
12) Install tripod joint spider (2) on shaft by using special tool with
hammer, facing its chamfered spline inward (wheel side), then
fasten it with snap ring (3).
Special Tool
(A): 09900-06107
(B): 09925-98221
13) Apply grease to tripod joint and inside of housing then install
housing. Use grease supplied with spare parts.
"A": GKN1 LUBER C grease/Color: Amber or brown &
semi-opaque
Grease capacity: About 85 – 105 g (3.0 – 3.7 oz)
FRONT DRIVE SHAFT 4-9