Suzuki WagonR+ RB310 Service Manual page 2497

6A1-22 ENGINE MECHANICAL
6) To take up slack of timing belt, turn crankshaft two rotations
clockwise after installing it. After making sure that belt is free
from slack, tighten tensioner stud first and then tensioner bolt
to each specified torque.
Then confirm again that two sets of marks are aligned respec-
tively.
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)
.
(b): 22 N m (2.2 kg-m, 16.0 lb-ft)
7) Install timing belt outside cover.
Before installing, make sure that seal is between water pump
and oil pump case.
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)
8) Install crankshaft pulley (2).
Fit hole of pulley to pin (1) on crankshaft timing belt pulley, and
tighten pulley bolts (3) to specified torque.
Tightening Torque
.
(a): 16 N m (1.6 kg-m, 11.5 lb-ft)
9) Clamp harness securely.
10) Install water pump pulley (1) and drive belt.
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)